The Calix 804Mesh unit is a WiFi extender offered by TCT to give you a wider range of service.


Instructions 

In order to connect your 804Mesh to your WiFi One router follow these instructions: 

  1. Connect the 804Mesh to your WiFi One using the WPS functionality built into both products. Press and hold the WPS button on the Wifi One router for at least 5 seconds. When released, the WPS LED will blink amber. 
  2. Then go to the 804Mesh and hold the WPS button until the signal strength LEDs begin
    flashing. At this point, a pairing attempt will begin.

    • You have a maximum of two minutes between button pushes (walking
      time).

  3. Wait for the LED indicator to stop blinking and refer to the chart below to signal strength.

    • Allow 5-10 minutes for the LED indicator to stop flashing, it may be performing an update.


LED DisplayComment
The 804Mesh is too close to your WiFi One router.
The distance between the 804Mesh and the WiFi One is optimal.
The distance between the 804Mesh and the Wifi One is optimal.
The distance between the 804Mesh and the WiFi One provides adequate results.
The 804Mesh is too far away from your WiFi One router.